Building, remodeling or rebuilding a home in Belmont, CA
On this page: Contacts · ADUs & JADUs · SB 9 · Tear down & rebuild · Remodels & additions · Fees · Seismic · Electrification & PG&E · Cost context · Not published · Sources
Building and planning contacts
- Permit Center: 1 Twin Pines Lane, Belmont. Building Division (650) 595-7422, permitcenter@belmont.gov. Planning and Zoning (650) 595-7417, cdev@belmont.gov. [1][2]
- Registered users can search permits and apply for eligible express residential permits in eTRAKiT. [3]
ADU contact listed by the county ADU Resource Center: Planner on Duty
Phone: 650.595.7478
Local ADU Website
ADU Ordinance [4]
ADU and JADU rules
This table is from the San Mateo County ADU Resource Center (run by 21 Elements, a partnership of the county’s cities and the County), page updated March 10, 2025 [4]. Confirm details with the city before you design.
| Size | Min: 150 square feet Max detached (one bedroom or less): 850 square feet Max detached (two bedrooms or more): 1000 square feet Max attached: the greater of 50% of primary dwelling square footage or 850 square feet (one bedroom or less) / 1,000 square feet (two+ bedrooms) |
|---|---|
| Height | Attached: Same as primary dwelling Detached: 16 feet Over garage: 20-23 feet (dependent on roof style) *Over garage, if setbacks meet underlying zoning regulation: 28 feet |
| Setbacks | Attached: California Gov. Code, § 65852.2, subd. (a)(1)(D)(vii): 4-feet side and rear Detached: rear and side – 4 feet; front – depends on zoning district; 5 feet from primary dwelling unit |
| Parking | No parking required but, if provided, can be tandem |
| Owner occupancy | Owner must live in the main dwelling or the ADU unless ADU was permitted between Jan 1 2020 and Jan 1, 2025 |
| Process & timeline | Making an appointment to meet with a planner in the initial stages of the project can help avoid challenges and is highly recommended. Building permit and design review are required. |
| Exceptions | ADUs must comply with Residential Design Criteria if the new construction includes 1) ground floor plate height exceeding 12-feet or roof height exceeding 18 (measured from finished grade) or 2) creates or expands an upper floor. |
| Other local requirements | Sprinklers for fire safety are required if the ADU results in a 50% increase in the original residence size or if a combination of increase in size and remodeling impacted 50% of the original square footage. All projects removing protected trees are subject to the Belmont Tree Ordinance. No short-term rentals allowed Only one ADU and one JADU per property is allowed in Single-Family Residential Districts. No more than two detached multi-family ADUs are allowed on sites with lawfully existing multifamily dwellings. Sewer must connect to the lateral for the main dwelling. |
| Zones allowed | All zones used for single or multifamily housing: R-1-5, HIA-1, VHDR, HRO, CMU, VC, VSC, VCMU, PD (Residential) |
| Minimum lot size | None |
- Belmont has only ministerial (no-hearing) ADU standards. Compliant ADUs are approved with the building permit; owners sign an acknowledgment that the ADU cannot be sold separately and cannot be rented for less than 30 days. [5]
- Pre-approved ADU plans: homeowners pick a plan from the City’s gallery, buy it from the designer, and submit a site-specific application; staff review a complete application within 30 days. [6]
- State baseline (all California cities): the city must approve or deny a complete ADU/JADU application within 60 days when there is an existing home; JADUs are limited to 500 sq ft inside the home; and ADUs of 750 sq ft or less pay no impact fees. [7][8]
SB 9: two units or a lot split
- Belmont publishes a Senate Bill 9 (SB 9) Packet on its applications page. [2]
- The City’s SB 9 FAQ notes that SB 9’s limit on demolishing more than 25% of exterior walls applies to all units unless a city ordinance allows more. [9]
- State rules (SB 9): ministerial approval of up to two units on a single-family lot, or a split into two lots of roughly equal size (neither under 40%, each generally at least 1,200 sq ft); the city must allow units of at least 800 sq ft; no demolition of rent-controlled, deed-restricted affordable or recently tenant-occupied housing; lot-split applicants sign a three-year owner-occupancy affidavit. [10]
Tearing down an old house and building a new one
City demolition permit and local restrictions
- Demolition permit applicants submit three sets of plans (min. 11"×17"), a plot plan at 1/8"=1', and a list of construction and demolition recycling providers, per CALGreen debris-recycling rules. [1]
- Protected trees: apply online, the City arborist visits (contact within 72 business hours), permit fee $92, post the notice 48 hours before removal, remove within 60 days, and replant (typically one 15-gallon tree) or pay $611 in-lieu per tree. Trees tied to building or planning permits are reviewed with those permits. [11]
Steps every teardown needs (regional and state rules)
- Air District “J number.” Every demolition of a load-bearing structure needs a Bay Area Air District demolition notification (J number), regardless of asbestos content, at least 10 working days before work starts; for buildings with four or fewer units, 72-hour notice is allowed for an extra fee. Cities require the J number before issuing a demolition permit. [12][13]
- Asbestos. For homes with four or fewer units, a full asbestos survey is not required, but specific materials (HVAC ducting, acoustic ceilings or plaster, textured walls, cement siding or stucco, resilient flooring) must be sampled and tested if they will be disturbed. [12]
- Lead paint. Renovation, repair and painting work that disturbs paint in homes built before 1978 is covered by EPA’s lead-safe RRP rule, which requires certified firms. [14]
- Gas and electric disconnect. Request the disconnect through PG&E Building and Renovation Services (Your Projects). PG&E removes the meter and cuts gas service at the main or property line. [15][16]
- Water and sewer. Water meter removal and sewer lateral capping are handled by your water provider and sewer agency; specific steps are listed above only where the city publishes them. Otherwise, the steps are not published on the city pages we checked.
Design review, floor area and height for the new house
- Belmont has Single-Family Design Review. Its FAQ says additions of 400 sq ft or more generally require Planning Commission review; ask Planning (650-595-7417) whether your new home or teardown triggers it. [17]
Published rebuild timelines and fees: beyond what is listed above, the city does not publish a total teardown-to-rebuild timeline or an all-in fee figure on the pages we checked. Not published.
Remodels and additions
- Smaller residential jobs may qualify as express permits through eTRAKiT; larger remodels go through plan check at the Permit Center. [3][1]
- The California Residential Code that cities adopt (Section R105) requires a permit to build, enlarge, alter, repair, move or demolish a home or to change its electrical, gas, mechanical or plumbing systems. Section R105.2 exempts minor work such as painting, papering, tiling, carpeting, cabinets and countertops. Cities can amend these rules. Whether a job is issued over the counter or online or needs full plan check depends on the city, so ask the building division. [18]
Fees the city publishes
- Sample ADU permit fees reported for recent permits: ADU 1 (584 sf, attached): $6,736
ADU 2 (416 sf, attached): $3,404
ADU 3 (285 sf, attached, junior): $3,399
ADU 4 – August 2022 (348 sf, detached): $18,927 [4] - Belmont lists its planning and building fee information on the Permitting Applications, Forms, and Fees page. [2]
- School impact fees are set by your school district, not the city. Residential additions of 500 sq ft or less are exempt under Education Code §17620; check your district for the current rate. [19]
- ADU impact fee waiver: no impact fees on ADUs of 750 sq ft or less or JADUs of 500 sq ft or less; larger ADUs pay in proportion to the main home’s size. [7]
Seismic retrofit programs
- Earthquake Brace + Bolt (EBB): grants of up to $3,000 toward a code-compliant retrofit for houses built before 1980 with a raised foundation or crawl space, in eligible ZIP codes, with a supplemental grant for households earning $94,480 or less. Registration opens in rounds, so check your ZIP. [20][21]
- Earthquake Soft-Story (ESS): grants of up to $13,000 for qualifying homes with living space over a garage or open ground floor. [20]
- No mandatory soft-story retrofit ordinance was found for this city on the pages checked. [20]
Electrification rules and PG&E service
- WestLight Energy (the county’s community energy provider) lists Belmont among San Mateo County jurisdictions with a reach code. Some reach codes require all-electric new construction, while newer ones use energy-performance targets instead. San Mateo County’s own 2025 reach code, for example, no longer mandates all-electric. Ask the building division which version applies to your permit date. [22][23]
- New or upgraded service: new electric and gas service, service upgrades (for example for an all-electric home or EV charging) and relocations are requested through PG&E Building and Renovation Services. Apply early, because utility work is often on the critical path. [16][24]
Typical cost context (published estimates only)
- The San Mateo County ADU Resource Center gives a very rough placeholder of $450–$600 per sq ft for ADU construction plus design and fees. Hard costs are typically about 85% of the budget, ranging from about $30,000 for a simple interior conversion to $400,000+ for a large hillside detached ADU. Kitchens run $25,000–$50,000 and bathrooms $15,000–$25,000 each. These are estimates, not quotes. [25]
- For new custom homes, full rebuilds and large additions, no city in this batch publishes a cost-per-square-foot figure, so we do not quote one. Get written bids based on your plans. [25]
Not published or not verified
- Belmont’s building permit fee amounts were not copied here; use the City’s fee page.
- No published demolition or rebuild timeline was found.
- The ADU Resource Center’s Belmont page was last updated March 10, 2025.
Planning a build, ADU, SB 9 split or remodel?
Tell us about your lot and your goals and request a free, no-obligation consultation. We can help you sort out which permits and rules apply before you hire a designer or builder.
Get a free build/remodel consultationSources
- City of Belmont: Building Department (Permit Center)
- City of Belmont: Permitting Applications, Forms, and Fees
- City of Belmont: eTRAKiT Web Portal
- San Mateo County ADU Resource Center (21 Elements): Belmont local ADU rules (source page updated March 10, 2025)
- City of Belmont: Accessory Dwelling Units
- City of Belmont: Pre-Approved Accessory Dwelling Unit program
- California HCD: ADU Handbook (March 2026, PDF)
- California HCD: Accessory Dwelling Units (state ADU program page)
- City of Belmont: SB 9 FAQ (City Council attachment B)
- California HCD: SB 9 Fact Sheet (PDF)
- City of Belmont: Trees and Removal Permits
- Bay Area Air District: Asbestos Frequently Asked Questions (PDF)
- Bay Area Air District: Regulation 11, Rule 2 (asbestos demolition, renovation)
- U.S. EPA: Lead Renovation, Repair and Painting (RRP) Program
- PG&E: Gas Service Projects (gas disconnect guide, PDF)
- PG&E: Building and Renovation Services
- City of Belmont FAQ: Single-family design review
- 2025 California Residential Code, Chapter 1 (Section R105 Permits), via UpCodes
- California Education Code §17620 (school facility fees on residential construction)
- California Residential Mitigation Program: Check your eligibility (Earthquake Brace + Bolt, Earthquake Soft-Story)
- California Residential Mitigation Program: Program ZIP code search
- WestLight Energy (San Mateo County community energy provider): Reach Codes
- County of San Mateo: Summary of New Construction Reach Code (PDF)
- PG&E: Building and Renovation application resources
- San Mateo County ADU Resource Center: Budgeting & Finance